Brakes making a noise or the pedal not feeling right? We measure pad thickness and rotor condition at your location and tell you what the figures actually show.
Brake noise or a soft pedal? We measure the pads and rotors where the car sits and give you the figures.
Expert Brake Technicians
Pad thickness and rotor runout measured and shown to you, since no Tennessee inspection is going to flag them for you.
Emergency Brake Repair
24/7 emergency brake support to address squeaks, pulls, or failures whenever you need help.
1
2
3
Tennessee does not require a periodic safety inspection, and Shelby County no longer runs emissions testing, so nothing on the calendar tells a Memphis driver their pads are low. It gets found by ear, usually once the noise has been there a while. Local driving hides it too. The I-240 loop and the Poplar corridor are stop-and-go for a good part of the day, and that kind of driving works brakes constantly at low speed where a squeal is easy to miss with the windows up. We measure pad thickness and check the rotors for runout, then show you the figures so the call is yours rather than a guess.
Brake wear and oil condition get measured at much the same mileage, so the other routine item worth doing on the same visit is covered on Oil Change Memphis. We also bring the wider range of upkeep work to the vehicle, which is covered on Car Repair and Maintenance Service Memphis TN.
The brake jobs Memphis drivers call 901-401-9868 about most often, and what the visit involves.
Squeal that turns into a grinding noise. Squeal is often the wear indicator doing its job. Grinding usually means the friction material is gone and the backing plate is against the rotor, which takes the rotor with it.
Pedal going soft or sinking. Air in the lines, a leaking caliper or a failing master cylinder all feel similar from the driver’s seat. We check fluid level and condition, then look for a leak at each corner.
Steering wheel shaking under braking. Normally rotor thickness variation rather than a wheel balance problem. We measure rotor thickness against the minimum figure stamped on the hat before deciding between machining and replacement.
1
2
3
Brake work is where guessing costs the most. We measure the friction material and check the rotors for runout and thickness variation, then tell you what the numbers are. If the pads have life left in them, that is what you will be told, and a noise that turns out to be surface rust after a wet spell is not a repair we will invent.
4
24/7 emergency brake repair, call now at 901-401-9868 for immediate, dependable service.