Brakes making a noise or the pedal not feeling right? We measure pad thickness and rotor condition at your location and tell you what the figures actually show.
Brakes due for replacement? We measure what is left on the pads and rotors first, so you replace only what is actually worn.
Years of Brake Expertise
Pad thickness and rotor runout measured and shown to you, since no Tennessee inspection is going to flag them for you.
Emergency Brake Service
Emergency brake services available 24/7 to get you back on the road safely whenever you need assistance.
Request Brake Service
Inspection & Diagnosis
Repair & Testing
Brake work is where guessing costs the most. We measure the friction material and check the rotors for runout and thickness variation, then tell you what the numbers are. If the pads have life left in them, that is what you will be told, and a noise that turns out to be surface rust after a wet spell is not a repair we will invent.
Summer heat is hard on a vehicle in this city, so the other job worth doing while we are at the car is covered on AC Installation & Repair Memphis. The rest of what we repair at your location is covered on Auto Repair Shop Memphis TN.
The brake jobs Memphis drivers call 901-401-9868 about most often, and what the visit involves.
Squeal that turns into a grinding noise. Squeal is often the wear indicator doing its job. Grinding usually means the friction material is gone and the backing plate is against the rotor, which takes the rotor with it.
Pedal going soft or sinking. Air in the lines, a leaking caliper or a failing master cylinder all feel similar from the driver’s seat. We check fluid level and condition, then look for a leak at each corner.
Steering wheel shaking under braking. Normally rotor thickness variation rather than a wheel balance problem. We measure rotor thickness against the minimum figure stamped on the hat before deciding between machining and replacement.
Frequently Asked Questions
Which vehicles can you perform brake replacement on?
What should I do if I hear brake noise or feel vibrations?
How long does a typical brake replacement take?
Do you use OEM or aftermarket brake parts?